Skip to main content

Load the PowerShell Module

The following steps are provided to load the Threat Prevention PowerShell module. These steps are required with each PowerShell session before running the available APIs.

note

The command below assumes the Threat Prevention installation directory is in the C drive on the server where the PowerShell console resides.

Step 1 – Run the following command to load the module into PowerShell. The highlighted part of the command assumes the default installation directory, but a custom path can be used.

Import-Module “C:\Program Files\Netwrix\Netwrix Threat Prevention\SIEnterpriseManager\SI.SIMonitor.PowerShell.dll”

Step 2 – Connect to the Enterprise Manager using the Connect-SIEnterpriseManager command. The following parameters may be used:

note

If PowerShell is running on a separate machine to the Enterprise Manager, at least the address is required.

  • Address [String] – Enterprise Manager IP address, default is 127.0.0.1
  • Port [String] – Enterprise Manager port, default is 3740
  • Reconnect [Bool] – Reset connection and make a new one

Example of Connect-SIEnterpriseManager without any parameters (PS and EM are on the same server):

Connect-SIEnterpriseManager

Example of Connect-SIEnterpriseManager using two of the above parameters:

Connect-SIEnterpriseManager -A 192.168.189.57 -R 1

PowerShell is now ready to manage Threat Prevention policies, collections, EPE settings, and integration settings with Netwrix Threat Manager.